Hairpin leg furniture is one of the hottest trends today, and today we’ll build a vanity with such legs with plans from PneumaticAddict. The supplies are (2) 1 x 18 x 48″, (2) 1 x 4 x 96″, (6) *full overlay cup hinges, (4) 26″ steel hairpin legs, a table saw, a miter saw, Kreg Jig®, a power drill and a cup hinge drill bit and guide. Start with your 1 x 18 boards. Cut both boards down to 46″ in length using a either a table saw or a circular saw attached to a cutting guide, like the Kreg Rip-Cut™. Next, cut the 1 x 4’s to length. On each 13 3/4″ piece, drill 3, evenly spaced pocket holes on the same side on each end. Head over to PneumaticAddict blog to keep reading.