DIY Burned Wood Jewelry Display

Diy Burned Wood Jewelry Display

Do you have lots of jewelry? Then, of course, you need a good display to arrange it right and not to forget of any piece. Take driftwood, screw in hooks, soldering iron, a drill, 1/8 & 1/4 drill bits, wood glue, a ruler, a pen, screws or nails. Start by burning your design into your driftwood. Straight lines and spots seem to be the easiest. When you have a design you like, mark the bottom with dots one inch apart. Drill little holes where you marked. Then dab a little glue on your hooks and screw them into the wood. Use both drill bits to pre-drill holes with sinkholes for your screws or nails. Screw or nail into the wall and that’s it! Get organized!

2 of 8
Diy Burned Wood Jewelry Display
3 of 8
Diy Burned Wood Jewelry Display
4 of 8
Diy Burned Wood Jewelry Display
5 of 8
Diy Burned Wood Jewelry Display
6 of 8
Diy Burned Wood Jewelry Display
7 of 8
Diy Burned Wood Jewelry Display
8 of 8
Diy Burned Wood Jewelry Display